DynaPump system offer real performance-price revenue advantages
.

  DynaPump Claims
  • Price Advantage
  • Ultra-Long Stroke
  • Flow Control Ratio 5:1
  • Variable Speed
  • Differential speed up/down
  • Adjustable automatic flow control
  • Communications for control and feedback
  • Computer Controlled Automatic Restart
  • Lightweight and Portable
  • Lower installation cost
  • Lower transportation cost
  • Low installed power requirements
  • Low power consumption
  • High electrical power factor (+97%)
  • Positive effect on electrical grid demands
  • Lower infrastructure costs
  • Higher flows than any other rod pumping units
  • Lower surface & down hole maintenance costs

    Receive a Quote

  Price

  • One-half the price or less of established technologies.
  • Lower installed cost, pump can be installed and operating in less than 3 hours.

  Lower Lifting Costs

  • 50% or lower power consumption per barrel of fluid pumped
  • Ultra-Long stroke allows for less strokes per minute, less strokes equal fewer parted rods. Also, the SPM can be reduced, resulting in less work for the system and less wear on the rod string and pump.
  • When using a natural gas engine drive system, it requires 1/3 the horsepower rating of a matching beam pump driver thus, producing an energy savings of approximately 70%.
  • Automatic pump-off controller (never stops)
  • Normally uses a much larger bottom hole pump
  • 5.75" and 7.5" bottom hole pumps available.
  • 1 1/4 sucker rods available.
  • On-Off tools properly dimensioned for DynaPumps increased load capacity are available.


  





Claims | Case Studies | Engineering Reports | Flow Comparison Chart | Client List